How to keep your beard tidy between barber visits
Raees KiplingMaster Barber
Published

Keeping a beard tidy between barber visits comes down to three edges: the beard neckline, the cheek line and the overall length. Get those right with a decent trimmer and a steady hand, and your beard keeps that freshly shaped look for much longer. Below is how to find each line, how to trim without taking too much off, and how to keep a beard fade soft at home until your next visit.
The kit you need
A beard trimmer with a set of guards, a small pair of sharp scissors, a fine tooth comb and a good mirror. Trim when the beard is clean and dry. Wet hair hangs longer than it really sits, so it is easy to take off more than you meant to.
Finding your beard neckline
The neckline is where your beard stops and your neck begins. Set it too high and the beard looks like a chinstrap from the side. Set it too low and it creeps down your neck and looks untidy.
The two finger guide
Place two fingers flat above your Adam's apple. The top edge of your fingers marks roughly where the neckline should sit at the centre. From there, picture a soft curve running back under the jaw to just behind each earlobe, a bit like a wide U shape.
Trimming below the line
Tilt your head back a little and take the guard off the trimmer. Work from the line downwards towards your neck, never upwards into the beard. Go slowly, a little at a time, and check both sides in the mirror. If in doubt, leave the line slightly lower. You can always take it higher next time.
Let the barber set it first
The easiest neckline to keep is one a barber has already set. At Bladerunners, a beard trim brings back the length, balance and outline in one go, so all you need to do at home is follow the lines. If your shape is fine and you only want the edges crisp again, a beard line up sharpens the cheek line and neckline. Prices for both are on our price list.
Tidying the cheek line
The cheek line runs from the sideburn down to the corner of the moustache. A natural cheek line only needs the odd stray hair removing above the main growth. If your barber has cut a sharper line, follow it exactly with the edge of the trimmer rather than drawing a new one. Every time you take it lower, the beard looks thinner up top, and that is slow to put right.
Trimming the length
Comb the beard downwards first. Then run the trimmer over the cheeks and jaw with a guard one size longer than you think you need. Check it, and only drop a grade if it still looks too long. Do the chin last. It usually stays a little longer than the sides to keep the shape.
Finish with scissors. Snip any hairs that stick out after combing, and trim the moustache along the top lip so it sits clear of your mouth.
Keeping a beard fade blended
A beard fade blends the sideburns into the beard so there is no hard step where your haircut meets your face. At home, you can keep it soft by running a short guard a little way up the sideburn, then the next guard up slightly higher. Do not chase the blend too far. Rebuilding a fade properly is a job for the barber's chair.
If you are still deciding which shape to grow, start with our guide to beard styles and shapes.
Common mistakes to avoid
- Trimming wet: the beard dries shorter than it looked.
- Neckline too high: the beard loses its shape and looks thin from the side.
- Chasing symmetry: taking a bit off one side, then the other, until both are too short.
- A blunt trimmer: it pulls rather than cuts, so keep the blades clean and oiled.
Questions people ask about beard upkeep
Should I trim my beard every day?
No. Two or three times a week is plenty for the neckline and cheeks, and the length only needs attention every week or two. Trimming daily makes it easy to take off too much without noticing. A few light passes a week keeps it neat.
What if I take my beard neckline too high?
Stop and let it grow back. Do not try to even things up by going higher on the other side. Leave the neckline alone for a couple of weeks, then let your barber reset it. A line trimmed slightly too high recovers far quicker than one pushed higher still.
Which guard should I use to trim my beard at home?
It depends on the style. Start long, such as a number 4 or above for a full beard, and work down a grade at a time. Stubble usually sits around a number 1 or 2. Write down the guard your barber used so you can match it.
How do I stop my beard feeling wiry between trims?
Wash it with a gentle beard wash rather than ordinary shampoo, dry it well and work in a little beard oil or balm. Comb it through daily so the hairs lie in the same direction. Snipping split, frizzy ends with scissors helps it feel softer too.
Get your lines reset
When home trimming stops keeping up, call the shop on 07923 042050 or visit us at Crystal Peaks Market, Sheffield. We are open Monday to Saturday, 9am to 5pm. Ask for a tidy up with our beard trim and our barbers will set lines that are easy to follow at home.



